Shingle Shed Roof Top Edge

The flashing turns down and just covers the top edge of the fascia board.

Shingle shed roof top edge.

Determine when to stop laying three tab shingles and switch to ridge caps. Shingling a shed and want some tips. Fold the top of the shingle over the ridge. Lay the entire first row one at a time nailing each down with one inch roofing nails.

When you reach the other end of the roof trim any excess off the last shingle with a utility knife. How to finish the top shingle row on a shed roof. How to shingle a shed roof ridge. Continue on down the line nailing on both sides and covering the nails with the next shingle tabs.

Our contemporary house has a shed roof that is finished with a layer of aluminum flashing nailed through the top course of shingles. The roof is shingled. Start installing roof shingles in order to make your roof water tight and to eliminate wind infiltration first place tar on the bottom edge of the roof and lay a row of roofing shingles upside down all the way across the. Place one nail at each corner a little way in from the edges and then one if not two in the middle.

Nail the fold over to the other roof deck. Cut the tab off the start shingle so that the edge is smooth and in line with the edge of the roof. Apply sealant over exposed nails on the last strip. The tabs of the last row of shingles should come within 5 1 2 of the ridge.

Use more sealant along the top edges of all shingle strips. Roofing shingles come in strips that are generally about 3 feet long and 8 or 10 inches wide. Use roof tar to hold down the end of the shingle and nail on both sides of the peak making sure that the tabs from the next tile will cover them. I would would take the shingles up to the edge and use pretty much a right angle piece of flashing to cap over the shingles and the edge.

Watch and see how easy it is. Ensure strips are wide enough to cover nails. Lay the first ridge cap. To do this begin on one end of the ridge and place the ridge cap so.

You will know it is time to switch to ridge caps when the non. How to finish the top edge of a shed roof for the final row cut shingles into strips.